Skip to content Skip to main navigation Skip to footer

Vision: How to Check the USB Cable Connection on the Mainboard?

Step 1. Switch off the machine.
Step 2. Unplug the power wire, loosen the 6 screws that secure the cover of the main control board.

mceclip0.png

Step 3. Unplug and replug the USB wire(No3). You may need tweezers to peel off the glue on the surface first.

Main Control Board.jpg

Step 4. After unplugging and replugging, please plug the power wire (No.12) into the mainboard and turn on the machine and wait for the machine to rise to the highest position, the laser module moves to the rear left in the standby state.

mceclip2.png

Step 5. Open MakeIt software>click on New project>switch to USB mode to see if the connection is successfully setup or not. 

Was This Article Helpful?

0
Related Articles