Explanation on the Debug Panel in MakeIt Software

Control+Shift+P(Command+Shift+P for mac) to bring out the panel.

Ensure the laser is powered on and connected either via USB or WiFi.

Command you might need to use: 

Open LOG

Open G-code File

Homing

Rise

Descend

Cooling System On/Off

Exhaust System On/Off

Air Assist On/Off

Upload G-code File

Continue

Pause

Cancel

Detect Rotary Set

Test Rotary Set

OTA File Upload

Open LOG, which can also be found in settings. Open Log

Open G-code File. G-code File

Homing: To let the laser module return to the rear left corner for homing.

Rise: To let the laser rise to the full height

Descend: To lower the laser to idle mode. 

• Note: While Vision model is set to rise automatically once powering on, it won’t lower once you power it off.
  • You can also go to settings to lower it.
    Transportation Mode
    Idle Mode

Cooling System On/Off: To test if the laser module fan is working on not.

Exhaust System On/Off: To test if the exhaust fan is working or not.

Air Assist On/Off: To test if the air assist set is working or not. Vibrating if on. 

Upload G-code File: To test if there is an issue with the laser’s performance.

Continue: To resume the task after pausing midway.

Pause: To mid-stop a task.  you may also open the lid or simply click Pause in Processing Window.

Cancel: To cancel a task. You may also long-press the start button on the front or click Cancel in Processing Window.

Detect Rotary Set: To check if the rotary set is installed properly with the motor wire inserted.

Test Rotary Set: To test if the rotary set can rotate or not to engrave tumblers

OTA file Upload: To resolve firmware abnormality issue.