Auto Pass Through Feeder

Before using, please make sure you have

• Software Version: 2.0.3 or newer
• Firmware Version: 2.0.24 or newer

Follow the instructions to assemble the Auto Pass Through feeder properly.

• Related Post: 【Video】How to Install the WeCreat Auto Pass Through Feeder

Select the processing mode on the right side of MakeIt software.

Note:

• Use flat materials without warping edges.
•  When using the Pass-through Feeder, the laser module works only in the area above the red line. So the part of material extending inside the laser machine must exceed the red line (>10cm).